How to prepare a tooling brief
Start with the workpiece, feature, material and operation constraint; a catalogue number can help, but it does not replace the machine, operation sequence and observation.
Read article →Knowledge base
Knowledge before selection.
Technical articles that help prepare a focused conversation with a process engineer.
When clamping is the root cause
Before changing the tool, describe workpiece datums, support and clamping and when the observation occurs; assess workholding separately from toolholding and programme strategy.
Read article →What to assess before regeneration
Before regeneration, record the operation, material, wear pattern and geometry required when the tool returns; tool-body condition and machine conditions may need separate assessment.
Read article →Toolholding vs workholding
Toolholding connects the tool to the spindle or turret, while workholding locates, supports and clamps the workpiece; identifying the relevant side of an observation structures the next check.
Read article →A brief for a postprocessor
A postprocessor brief describes the actual machine, control and intended CAM output; it does not replace a CAM programme, NC code, simulation or process consultation.
Read article →When to use CAPP and when to consult process design
CAPP organises agreed process-plan data, while process-design consultation assesses the production route itself; these tasks require separate information and methods of verification.
Read article →